Agfa accuset 1000 film feeding problems install#
Agfa accuset 1000 film feeding problems software#

I suspected the cable by having seen the name of this same site. I understood about when you say the flex that is inside the AccuSet serves both as to ApisCard to HWcard. I did not get on when you say that my example is impossible to be seen. VladCanada, thank you for donating your time. In order to rule out the POSSIBILITY of PC.ДЇorgive me the size of the post, is that I prefer to make it clear for those who are interested in helping. It was replaced by a PC Pentim duocore 3GHz - 2GB memory - but the results were the same. Note: Even in HW776 also happens to interrupt the filming giving the message Busy - RipActive - 3cm. Results similar to those of inkjet printers when the ink cartridge is at the end or dirty. Increased exposure to 255 (maximum).ДЎ - Small Format 325x7cm 2400 dpi - With circles latticesДў - Format of small 325x7cm 1200 dpi - With circles latticesДЈ - Small Format with vectors 100% black - 2400dpiДЎ - Failure: Towards the width of the film, the image came out good half and half missed out (cut points, intermittent blurry).Дў - Fairly good, the reticles out perfect, with a small blinking square on a drawing that came out distorted.ДЈ - Failures in the images, seemingly interrupted by white lines. We sent a small job which filmed with 127 exposure was very bad. What happens is that with XP installed to 776 new, new formatting, installation of plugins and rip everything from scratch. Tentatod was also HQ Torrent 6.0.ДЄlso tested were two different parallel wires, each with the same result.

Agfa accuset 1000 film feeding problems software#

Just to be clear: the hardware settings and software are:ДЄthlon XP - 512 RAM - 80GB HD - Windows XP - Navigator 7.03 - Plugin Highwater downloaded on the website of Xitron. Then ask the vendor to send us one 776 and he did two weeks later. Then gave up the 476 diagnosed card problem. We follow guidance, HW476 until communicated with the AccuSet filming some pages, only to give back the message Busy - 0cm.

Agfa accuset 1000 film feeding problems install#

I consulted a technician by phone, Wed directed me to install Windows 2000 Professional, for HW476 not work with Windows XP. The seller sent me a maliciously HW 476 that did not work, the message that appeared was Busy - Rip Active - 0c and nothing filming. I decided to purchase a PCI card HW 776 8bit. I did not use the taipan, also because we have no skill with it. In this test reticles contained, rectangles with exact measurements, recording four large pages (660 mm), everything perfect. Before buying it, testing was performed on a Taipan 2.1, the test came out perfect. Recently acquired a AGFA AccuSet 1000 Plus.